+33 (0) 492 38 88 20Support/HelpDesk : +33 (0) 492 38 86 86
info@dsf-tech.com

L-Series Range

L-Series Range

Controller

The L-Series Position Controller provides a building block approach to total engine management. The microprocessor-based bi-directional actuator design easily attaches to fuel pumps, mixers, or throttle bodies. The L-Series Position Controller accepts a position command and drives the 0–60 degree output shaft to the commanded position based on an internal shaft position sensor. The high-efficiency torque motor delivers 0.34 Nm (0.25 lb-ft) nominally over 60° travel range to operate fuel or air control devices.

Management system

The L-Series Position Controller accepts either a PWM, 0–5 V, or CAN command for output positioning. The command signals are issued by the appropriate supervisory engine management system, and the L-Series must be set up properly in software to expect the correct signal for the application.

Changes state

For status purposes, a relay driver output is available on the L-Series control which changes state whenever a fault or error condition is experienced by the controller.

– Low cost, small package actuator
– Extremely fast, bi-directional, electronically positioned in both directions
– All-electric actuator requires no drive or hydraulic supply

– 60° (±2°) rotary output
– Single or redundant position command signals
– Advanced diagnostics
– Tamper-resistant

– Configurable parameters to tailor to varied applications
– Easy setup and tuning using PC based Service Tool
– Optional CANopen and J1939 communications

For status purposes, a relay driver output is available on the L-Series control which changes state whenever a fault or error condition is experienced by the controller.

GET A QUOTATION
To contact customer support, please call +33 (0) 492 38 88 20 or send an email to support@dsf-tech.com.
To contact a sales representative, please send an email to info@dsf-tech.com.

For more information on the training documents, please call 04 92 38 86 86 or send an e-mail to laure.gillet@dsf-tech.com.

2017-06-29T14:38:09+00:00 3 May 2017|Controllers generators, Generators, WOODWARD|
68c9685bf25d1e77dfc2825e24a69a7fBBBBBBBBBBBBBBBBB